This program allows the users to upgrade their CR1200R firmware to version 2.60. CR1200R users can check their firmware version by pressing the SETUP key and selecting SYSTEM STATUS. Users of the software will be prompted during the initial setup to enter the appropriate model number (CR1200R). (Version 2.60 allows the user to save the Contrast setting and also is easier to control the Contrast with the dial.)

Please note that this upgrade will erase any current channel plan programming. We recommend that prior to upgrading, you view each of the channels in your channel plan and note which channels are 64 QAM, 256 QAM or any other special settings. That way you can easily put them back after the update.

If you like you can use the Remote Windows Software to update the channel plan on your computer rather than by using the front panel of the CR1200(R). Once you have updated the firmware and installed the Windows remote software, you will be able to store your channel plans on your computer and put them back in your instrument after future firmware updates. We apologize for the inconvenience.

AUTODIAG is now permanently "on" 
Contrast adjustment using the backlight key 
Enhanced 44 Mhz. IF measurements 
Channel table editing highlights active channel table first 
The POWERDOWN timer has variable times (instead of being "on/off") 

To use either the Remote Windows Software or the Firmware Upgrade Software with your CR1200(R) you will need a straight through RS-232 extension cable. This is a cable normally used to extend the length of an RS-232 connection with a DB9 female on one end and a DB9 male on the other. This type of cable is readily available at any computer or office supply store. As a convenience you can order the correct cable online from Connect World.

Order 6' Cable.   Order 10' Cable

Note that some straight through RS-232 cables come with lug nuts on the male end of the cable that is connected to the instrument. You will need to remove these lug nuts from the connector as they are already installed on the instrument.

Please fill out the following information prior to downloading either of the software packages. If you are downloading both packages you will only need to enter the information once. Note that there is no charge for the software and it may be freely distributed. All we ask is that all copies be registered by using the form on this page. All downloaded software is ©2000 Sunrise Telecom Inc. Since this is a free software package we will not be providing program disks. We suggest you keep the downloaded file on your hard drive for future use should you wish to reinstall the program at a later date. Your email address will be used to notify you of future releases of both software packages.